SWEDGEDRADIUSRODS
ALUMINUM PITMAN ARMS

S420 8wedged Aluminum Radius Rod, the ultimate in super-lite weight, featuring swedged ends for super strength. With 5/8" fine left and right hand threads. Available from 15" to 27" in 1 " increments.


S420M 8wedged Aluminum Radius rod, like above but with 8, 1/2" fine threads each end.

S421 8wedged Aluminum Tie Rod, bigger diameter than the radius rods but the same fine quality. With 5/8" fine threads on both ends. These are the ultimate in tie rods and drag links, available from 40" to 50" long.

S186 Aluminum Pitman Arm, 12" center to center and 3/4" 8
wide. Milled on both sides for weight savings. 

S186-1 Aluminum Pitman Arm, 14" Center to center.
 

COUPLERS

Once again, a Sander Engineering part that may look similar to others on the market, but in reality is different when you look closely. Our couplers are heat treated and case hardened in special fixtures we made to insure that the final product is not out of round. The whole point of a coupler is that it must be absolutely straight to maintain perfect alignment to prevent vibration and failure.  

S170 10-10 Coupler, spline steel coupler.

S170A 10-10 Aluminum Coupler, spline aluminum coupler.

S170W Winters Integral Coupler, spline steel coupler.

S317 10-10 Coupler with Bearing Diameter, 5" long coupler for use in the Sander drive line shifter and drive line with the coupler support bearing.

S317A 10-10 Aluminum Coupler with Bearing Diameter.

ROD ENDS
ALUMINUM JAM NUTS

S422L Steel Rod End, with left hand threads.

S422R Steel Rod End, with right hand threads.

S422LA Aluminum Rod End, with left hand threads.

S422RA Aluminum Rod End, with right hand threads.

S423L Aluminum Jam Nut, with 5/8" thread and 15/16" hex
size, left hand threads.

S423RAluminum Jam Nut, with 5/8" thread and 15/16" hex
size, right hand threads.

S423LS Aluminum Jam Nut, with 5/8" thread and 3/4" hex size, left hand threads.

S423RS Aluminum Jam Nut, with 5/8" thread and 3/4" hex
size, right hand threads.

S424 Moly Rod End, with right hand threads for use in rear
torsion arms.